Wrap feature

Hi
I can project a curve onto a cylinder, but cannot find where to wrap. I am
on '06, is that the reason, or should I look further?

TIA

 

Jean Marc,

Close the sketch, select the sketch in the feature manager, then
select insert>features>wrap.

Reaper.

 

"Reaper2561" <> a écrit dans le message de ...

<Jean Marc,

<Close the sketch, select the sketch in the feature manager, then
<select insert>features>wrap.

<Reaper.

Thanks a lot.

I would have put it somewhere around "curve" or "sketch". Lucky I got to
read about it in this NG, the translation is not obvious (in fact
impossible) to find in the French help file.

"To wrap" is translates to "Envelopper" IRL, and was translated as
"enroulement" (winding / rolling-up) in SW. (witch is correct if not related
to the inial English term)