Window xp & HP 1120c

Discussion in 'AutoCAD' started by sontfami, Jul 31, 2004.

  1. sontfami

    sontfami Guest

    I have just switched to Windows xp and AutoCAD 14 does not regonize the HP 1120C printer
     
    sontfami, Jul 31, 2004
    #1
  2. sontfami

    Bud Schroeder [Autodesk Inc.] Guest

    Hello,

    There was an ADI printer available for this for years but I have not seen it
    in a very long time. HP actually paid someone to write it. The 1120c is
    PCL3 so it's not going to work with any of the ADI drivers included with
    R14. But you can just use the system driver and it will work fine. You
    would be better off to go to AutoCAD 2005 for XP support and much better
    Windows System driver support.

    Hope this helps.

    Bud Schroeder
    AutoCAD Test Development
    Autodesk Inc.


    1120C printer
     
    Bud Schroeder [Autodesk Inc.], Jul 31, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Text Window

  2. AutoCAD main window is invisible.

  3. Close text window in lisp

  4. How to load saved waveform window back into awd without using filedialogue window?

  5. VXL-SKILL : How to find the schematic window from the layout window

  6. How to create a Window that can be docked into the AutoCad Window

  7. Long PLOT on HP 1120C. Why 44.6 cm???

Loading...