WF2- Simplified Rep on Drawing

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by Pierluigi Diletti, Jul 25, 2005.

  1. I'm trying to define a drawing view of a part using
    a simplified representation.
    But it's not possible to modify the view.
    In the panel "View States" the option "simplified representation" is not
    available.
    It was possible on 2001 and now, on WF2, it's only possible for assembly.
    Could anyone help me ??
    Thnks in advance

    Pier
     
    Pierluigi Diletti, Jul 25, 2005
    #1
  2. Pierluigi Diletti

    Jeff Howard Guest

    No help until WF3. Look at the thread "PTC strikes again :-(" from a few
    days ago.
     
    Jeff Howard, Jul 25, 2005
    #2
  3. Thanks a lot !!
    Pier
     
    Pierluigi Diletti, Jul 25, 2005
    #3
  4. Pierluigi Diletti

    peterbrown77 Guest

    PTC's "workaround" for this in WF1 and WF2 was to use a family table of
    the part. Of course, most users found this to be unacceptable since it
    created another model. As Jeff mentioned, it is back in WF3.
    Unfortunately, PTC pushed the release date back 6 months, from Sept to
    Mar 06.
    Regards
     
    peterbrown77, Jul 29, 2005
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.