Variables not nil?

Discussion in 'AutoCAD' started by BillZ, Mar 16, 2005.

  1. BillZ

    BillZ Guest

    R2005

    sdi = 1

    When I do a saveas on a drawing, any global variables that were in that drawing retain their value in the new drawing.

    I didn't think it was always that way in AutoCAD, was it?

    What variable do I need to set to remedy this.

    I tried acadlspasdoc both ways and it didn't do it.

    TIA

    Bill
     
    BillZ, Mar 16, 2005
    #1
  2. BillZ

    Doug Broad Guest

    Bill,
    I think that is typical. If you want to have a fresh start, then
    use the save command and then the open command.

    Saveas just continues the current drawing session under a
    different name.


    their value in the new drawing.
     
    Doug Broad, Mar 16, 2005
    #2
  3. BillZ

    BillZ Guest


    different name.    <

    Okay, Thanks.

    Bill
     
    BillZ, Mar 17, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Nil

  2. Nil used in a list

  3. cmdecho nil not accepted?

  4. nil variables

  5. real variables not equal????

  6. "nil" to nil

  7. SOS! SAVE ME! cdsSpice could not extract netlist: ERROR: NODE/NET IS NOT ON KEEP LIST AND NOT IN WSF

  8. Not enough licenses causing variables to reset? help ACAD 2002/ LD3

Loading...