USB TO PARALLEL

Discussion in 'AutoCAD' started by KEVINS, Jun 22, 2004.

  1. KEVINS

    KEVINS Guest

    i would like to know if any one has tried to run two plotters via a wireless print sever on a wireless network using parallel to usb adaptors & was it a success
     
    KEVINS, Jun 22, 2004
    #1
  2. KEVINS

    Don B Guest

    I've got this:
    see http://www.linksys.com/products/wireless.asp
    - Linksys BEFW11S4 Wireless-B Broadband Router
    - Linksys WMP11 in my workstation
    - Linksys WPC11 in my laptop
    - Linksys WPS11 connected via parallel to an HP Designjet 600
    - HP JD 280m in a HP cp1700 printer

    Works great, except the Designjet 600 spools deathly slow (but no slower
    than the old 25' parallel cable) due to WinXP drivers (Win2K was faster).
    Nothing I can do about it until I can afford a new plotter.

    HTH, Don
     
    Don B, Jun 22, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Spaceball 4000 serial to usb adaptation

  2. Parallel Dongle through USB port

  3. OT Flash-based USB stick with a capacity of 8 GB

  4. [HELP] SW 2003 with USB key

  5. Can R14 work with a USB port?

  6. Print directly to USB printer?

  7. r13 + xp + usb = headache

  8. plotting PLT to a USB printer

Loading...