Units and material Default

Discussion in 'SolidWorks' started by BobW, Oct 4, 2008.

  1. BobW

    BobW Guest

    I am using SW 2008. My default setting for units is mm.
    How can I change it so that when I open a new part the units are
    inches.
    Now I must go to Options / Doc Props and change it there for that
    particular doc.

    Also can I set a default for material?
     
    BobW, Oct 4, 2008
    #1
  2. BobW

    Wayne Tiffany Guest

    You need to make the changes in your template and then save the template.

    WT
     
    Wayne Tiffany, Oct 4, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. SI Units, Imperial Units, and why the two don't mix?

  2. Cdf and pcell. Init value and default value

  3. Cdf and pcell. Init value and default value

  4. Drawing Units vs Part Units

  5. Material units

  6. Globally Change Default Units

  7. Real to drawing units (architectural units)

  8. Changing Default Units

Loading...