Unicad Kernel

Discussion in 'Cadence' started by Aprameya, Mar 15, 2010.

  1. Aprameya

    Aprameya Guest

    I am using the Analog design environment in Cadence. When I source the
    initilization file before starting the CDE (Cadence Design
    Environment), it says "UnicadKernel_versionxx" not found. Is this an
    error or a warning message? Does it mean I don't have access to some
    of the tools (such as layout editor/waveform tools etc)? Will I still
    be able to run a simulation and expect valid simulation results?
    Thank you
     
    Aprameya, Mar 15, 2010
    #1
  2. Aprameya

    Andrew Beckett Guest

    Aprameya wrote, on 03/15/10 22:28:
    I think this comes from ST Microelectronics Environment setup. I don't know what
    the impact is (Unicad is the ST Microelectronics environment) - so you should
    contact them.

    Regards,

    Andrew.
     
    Andrew Beckett, Mar 16, 2010
    #2
  3. Aprameya

    Riad KACED Guest

    Dear Aprameya,

    Andrew's right, UnicadKernel is an STMicroelectronics tool.
    Please drop me an email on my personal mailbox and I shall give you
    contacts that are likely to help you on this issue.
    This tool has to be loaded as part of your ucdprod but I'll let the ST
    guys giving you all the details.

    Regards,
    Riad.
     
    Riad KACED, Mar 16, 2010
    #3
  4. Aprameya

    baps Guest

    As per my experience in this regard(while in ST almost 7yrs ago) you
    need to check whether your .ucdprod file is correctly created(with all
    the modules with proper versions).
    You need to run uker-conf command on the prompt to configure that
    file.Please correct me if I am wrong.
    --Bapi
     
    baps, Mar 17, 2010
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. CADENCE IC and linux kernel 2.6

  2. which is the solid modeling kernel based on csg

  3. Solid Works Kernel

  4. What Really Defines What A Kernel Is or Isn't ?

  5. reading trimmed surface by parasolid kernel

  6. Parasolid Kernel GO interface on Linux

  7. Please help me in ACIS geometry kernel

Loading...