unable to use driven feature component pattern

Discussion in 'SolidWorks' started by Gil Alsberg, Jul 15, 2006.

  1. Gil Alsberg

    Gil Alsberg Guest

    Hi,
    I would like to know if anyone of you stumbled across this message:
    "cannot pattern: could not find proper pattern location."
    It happens when I try to use the driven feature component pattern on
    assemblies where the driving feature is a curve driven pattern in component
    A which should drive the same pattern on inserted component B (both
    components are mated but component B has one degree of freedom and is
    therefore not fully defined in the assembly).

    thanks,
    Gil
     
    Gil Alsberg, Jul 15, 2006
    #1
  2. Gil Alsberg

    CS Guest

    This functionality currently only supports Linear Circular and hole
    wizard features.

    Regards,
    Corey
     
    CS, Jul 17, 2006
    #2
  3. Gil Alsberg

    Gil Alsberg Guest

    Well, Corey, after making some tests with it, apparently it supports also
    Fill Pattern and Sketch Pattern.

    Cheers,
    Gil
     
    Gil Alsberg, Jul 17, 2006
    #3
  4. Gil Alsberg

    CS Guest

    I didn't even think to test those, thanks.


     
    CS, Jul 17, 2006
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. curve driven pattern strageness is 2004 PS0

  2. Component pattern

  3. unable to align connectors on loft feature

  4. Linear feature pattern, unable to pick center of geometry

  5. insert feature driven pattern in assy SW05sp5

  6. Enhancement req - preselect for Feature Driven Pattern

Loading...