Unable to open HDI driver

Discussion in 'AutoCAD' started by Plotter, Apr 30, 2004.

  1. Plotter

    Plotter Guest

    I just installed a new plotter. When I plot I get a message
    " THE OUTPUT TO THE DEVICE MUST BE SPOOLED THROUGH A SYSTEM PRINTER BECAUSE OF A CONFLICT OVER AN I/O PORT. THE HDI HARDWARE CONFIGURATION WILL NOT TAKE EFFECT. SOME SYSTEM PRINTERS COULD POSSIBLY MESS UP OUTPUT. TO ALLOW DIRECT CONNECTION TO THE PORT ALL SYSTEM PRINTERS MUST BE RECONFIGURED TO NOT USE THIS PORT."

    This message only appears on some of our PC's and all where set up the same.
    The plot device is a KYOCERA km4845w. I need to have the system printer able to use the port so I can use the print utility, which allows me to download plt files without opening.
     
    Plotter, Apr 30, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. need ADI driver for v.2002 or ploter driver

  2. ADT-04 HP driver.. This driver is not digitally signed

  3. windows driver heavier than HDI

  4. paperspace lineweight problem with Calcomp HDI

  5. HPGL2 vs HDI

  6. gdiplot7.hdi

  7. Local vs Network Port for HDI Driver

  8. need ADI driver for v.2002 or a special plotter driver

Loading...