unable to align connectors on loft feature

in sw2006 when performing a loft feature without guide curves, solidworks
aligns wrongly the connectors, so there is no preview, and a error of
self-intersecting geometry occurs. so I click on the single connector which
solidworks shows and select "show all connectors", in response solidworks
shows me many connectors which I start then sorting and aligning. the
problem is that some of those connectors hide behind them many unrevealed
connectors, which if I move them there is a bunch of new connectors which
comes all from the same spot with an endless stream! sometimes when I select
one of them which overlaps in one point many others, then solidworks selects
also all the others! sometimes some of the connectors are stuck and wont
move at all!

very frustrating.... does anybody else has this problem? I'm almost sure
this is a bug.

Gil