TSMC 025 minimum density of a CTM area design rule.

Discussion in 'Cadence' started by boki, Apr 25, 2004.

  1. boki

    boki Guest

    Dear All,


    If I didn't pass this rule, how do I do? Thanks a lot!

    1P5M with MIM

    I use M4 + M5 for capacitor.


    Best regards,

    Boki.
     
    boki, Apr 25, 2004
    #1
  2. boki

    Bernd Fischer Guest

    Place dummy caps in your design.
    I believe a dummy cap could be M5 to CTM, without M4
    but I'm not sure here.
    Have a look in your design rule manual.

    Bernd
     
    Bernd Fischer, Apr 26, 2004
    #2
  3. boki

    boki Guest

    Thank you very much for this information.

    Best regards,
    Boki.
     
    boki, Apr 26, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to solve layout Minimum Density Area across chip / CHIP Area must be >= 14%

  2. Virtuoso Compactor Rules for tsmc .18 native

  3. Converting Assura rule deck to Diva rule deck

  4. UMC to TSMC Help!

  5. TSMC 90nm library spice deck

  6. PADS/ESD cells in TSMC & UMC 0.18u kits?

  7. DRC ERROR "minimum density"

  8. Is this possible, area of a sheetmetal part (square area)

Loading...