Trouble with Move & Copy Commands

Discussion in 'AutoCAD' started by Tony S, Jul 13, 2008.

  1. Tony S

    Tony S Guest

    I'm in need of some help. 75% of the time I use the "MOVE" or "COPY"
    command, the point of origin defaults to 0,0,0. If I slow down on my mouse
    clicks, everything is OK. If it did it all the time I could understand it
    but the faster I move, the worst it gets. It's extremely frustrating.

    I'm running Autocad Mechanical 2007.

    Any ideas?

    Thanks in advance

    Tony
     
    Tony S, Jul 13, 2008
    #1
  2. Tony S

    Guest Guest

    try replacing your mouse or changing the double cliktime.

    Bob
     
    Guest, Jul 13, 2008
    #2
  3. Tony S

    Tony S Guest

    Thanks Bob. After posting, I was thinking the same thing. I have a
    Logitech MX700 cordless mouse and I've had it for 4-5 years. I think it's
    time for a change.

    Thanks again.
     
    Tony S, Jul 13, 2008
    #3
  4. Tony S

    Guest Guest

    I have a cordless microsoft mouse and the middle button is sometimes a bit
    flakey. some of the corded mice seem to be a bit sensitive on the buttons.

    Bob
     
    Guest, Jul 13, 2008
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. copy/move a part of drawing

  2. API VBA: MOVE/COPY BODY

  3. Move Copy vs Surface offset

  4. Is it possible to change move/copy feature values via equation or per config?

  5. Move and copy body question

  6. For SWX 2006 - Move/copy a table from Sht 1 to Sht 2?

  7. Move Copy Bodies Followed by Combine

Loading...