TROUBLE WITH LINETYPES

I created a linetype that inserts a shape file that is a slope symbol. The
linetype works fine in the drawing it was created in. When you go to load
the linetype through the traditional linetype manager it gives this error.
(it is in a dialog box on the screen)

Bad definition of SLOPE-L at line 2 of the file M:library\Symbol
manager\linetypes\AE.lin



If I use the AutoCAD design center to load the linetype from the drawing it
presides in then it loads just fine. I would like to be able to load the
linetype through the linetype manager. Any advice would be appreciated.

*SLOPE-L,SLOPE LEFT
A,.253246,-.123275,.253246,-.123275,.253246,-.123275,.253246,-.123275,.25324
6,-.123275,[SLP-L,M:\LIBRARY\SYMBOL-MANAGER\SHAPES\AE,s=.025],.253246
*SLOPE-R,SLOPE RIGHT
A,.253246,[SLP-R,M:\LIBRARY\SYMBOL-MANAGER\SHAPES\AE,s=.025],-.123275,.25324
6,-.123275,.253246,-.123275,.253246,-.123275,.253246,-.123275,.253246


THESE ARE THE LINETYPES THAT IS IS HAVING TROUBLE WITH

 

Are the linebreaks as shown in your .lin file, or did they occur as a result
of posting with your newsreader? If the former, note that theres a linefeed
between the last two digits of one of your "pen down" values in each
definition.
___