Trouble placing dimensions in drawings

Discussion in 'SolidWorks' started by wc, Jun 12, 2007.

  1. wc

    wc Guest

    SW2006sp5

    Seems it's getting more difficult to place dimensions between simple
    edges... I'll usually have to try 4 or 5 times to just get it to select
    the edges, I end up with a lot of extra clicks just placing them and
    more clicks deleting the extraneous bs.

    The view is not Draft, the assembly is local and resolved, could it be a
    video card thing? Seems to have been going on a while, I just finally
    got fed up enough to post a question.

    I sure hope 2007 is better, I *know* it used to be better in SW.
     
    wc, Jun 12, 2007
    #1
  2. wc

    solidsmack Guest

    I would give your system a good cleaning, I usually use EasyCleaner -
    gets the registry, unneeded files, and more. Then use PerfectDisk to
    get those fragments cleaned up.

    If you're still having problems after that you may want to try a clean
    install and re-install. I know that's a typical Tech support answer,
    but it could help.
     
    solidsmack, Jun 12, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Placing a block on top of selected points

  2. placing a "-" at the beginning of every line in Mtext

  3. Why are those nmos and pmos jumbled when placing cell using SE?

  4. VXL placing cells/pcells off grid

  5. WF3: Trouble Selecting Detail items and dimensions

  6. trouble Inserting OLE objects into drawings

  7. Trouble with inserting model items in drawings.

  8. Trouble Plotting Multiple Drawings

Loading...