Tooltips - solution found

Discussion in 'AutoCAD' started by DonB, May 15, 2005.

  1. DonB

    DonB Guest

    YAHOO!!

    Well I finally figured out how to change a tooltip on a button. I had asked
    earlier how to change the tooltip once I pressed a button that would change
    my cursor size from 10% to 100% and then back again. I wanted the tooltip to
    say, "CHANGE CURSOR TO 100%" when it was at 10% and then to say "CHANGE
    CURSOR TO 10%" when it was at 100%. I could have lived without it but being
    curious about these things I just knew that there was a way to do it.

    Now I can get on to other programming ideas.

    Cheers to all

    DonB
    Windsor, Ontario, Canada
     
    DonB, May 15, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Is there any solution which can identify that a string is a number or character

  2. Are reactors the best solution?

  3. Solution for commands nested more than 4 deep

  4. solution, thanks Stephan Koster

  5. simulate tooltips for line length

  6. Need a few solution

  7. regarding sourcelink solution 11025256

Loading...