Toolbox Fastener Problems

Discussion in 'SolidWorks' started by Terry Robb, Jan 6, 2004.

  1. Terry Robb

    Terry Robb Guest

    I work on assemblies at home from time to time and then take them to work.
    When I open the assemblies at work several of my fasteners change in size
    and I have to edit them one at a time to restore them to their intended
    size. Working in 2001Plus.
    Is there anything that can be done to prevent this?

    Thanks,
    Terry Robb
     
    Terry Robb, Jan 6, 2004
    #1
  2. I assume because your not copying the entire assembly (fasteners and all)
    when you go to work. I believe toolbox leaves inserted fasteners in folder
    in it's program folder. Therefore when SW opens your assembly, it's opening
    fasteners you created for another assembly some time ago. You need to click
    the reference box when doing a saveas and check the fasteners also.

    Keith
     
    Keith Streich, Jan 6, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.