Toobox & saved assembly

Discussion in 'SolidWorks' started by ZiaGiusy, May 11, 2004.

  1. ZiaGiusy

    ZiaGiusy Guest

    I saved an assembly file on a CD-R, but when i open this file on another pc
    with the same SW2004 installed, all the fasteners created with the Toolbox
    feature of SW did not match the original sizes (for example a screw that
    originally was M4 x 10 is shown like a enormous screw that occupies all the
    screen).

    There is some special option to save correctly the files with the proper
    standard parts sizes?

    Thanks, Roby
     
    ZiaGiusy, May 11, 2004
    #1
  2. ZiaGiusy

    Pete Guest

    If you use save-as there is a box called references, when clicking this box
    it give you the option of sending all referenced parts to the new folder
    therefore eliminating this problem!
     
    Pete, May 11, 2004
    #2
  3. ZiaGiusy

    ZiaGiusy Guest

    All OK! Thanks!

    Roby
     
    ZiaGiusy, May 11, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Chip Assembly and Pad Assembly in ICC???

  2. Exploding sub-assembly in a assembly

  3. Assembly and Sub-Assembly BOM

  4. Exporting Assembly using assembly coordinate

  5. Design table generated assembly does not stick to its table parameters inside another assembly

  6. reoder assembly pattern features (assembly)

  7. Getting Un-Saved ASsembly Doc Name (VBA)

  8. if a selectionset is saved when the drawing is saved

Loading...