To connect two gears

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by Ulises Diego, Jan 27, 2004.

  1. Ulises Diego

    Ulises Diego Guest

    I am using pro-E 2001, and to join two gears in motion I set two gears as
    pins and then connected them as a cam-follower connection (I remember I
    read something like that before), but unfortunately I have failed. I wonder
    if is for the deffinition of the surfaces (who should I determine that), any
    help will be very appreciatted.

    many thanks in advanced
     
    Ulises Diego, Jan 27, 2004
    #1
  2. Ulises Diego

    Solids Guest

    Wildfire has gear to gear timing in MDX
    works alot easier than setting something up in 2001
     
    Solids, Jan 28, 2004
    #2
  3. Ulises Diego

    Pete Guest

    This can be done in 2001 with a cam definition; don't forget to select
    the 'enable liftoff' checkbox.

    Regards
     
    Pete, Jan 28, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.