Tangent Face Constraint for 3D sketch splines

Discussion in 'SolidWorks' started by mbiasotti, Jan 28, 2008.

  1. mbiasotti

    mbiasotti Guest

    One important feature of 3D sketch splines that I did not have time to
    cover in my Curves presentation at SolidWorks World this year was the
    tangent face constraint.

    The reason that this is so important is that it does not often need a
    reference projected curve or intersection curve to be used as a
    "bridge curve." The problem is that it is rather undiscoverable in
    that you must pick both the spline, the edge it lies on as well as the
    surface to be tangent to. To see click on the following link. We are
    working on ways to make it more discoverable. I have included this
    with the PowerPoint that will be distributed to Conference Attendees
    soon.

    click here http://files.solidworks.com/special-videos/applying face
    tangent constraint.avi

    To play this video you might have to download the Techsmith codec
    from: http://www.techsmith.com/download/codecs.asp






    -------------------------
    Regards

    Mark Biasotti
    Product Definition New Concepts
    SolidWorks Corporation
     
    mbiasotti, Jan 28, 2008
    #1
  2. mbiasotti

    mbiasotti Guest

    mbiasotti, Jan 28, 2008
    #2
  3. Thanks, Mark. This might prove to be a real time saver. I often have trouble
    with the intersection curves in older models. They often forget that they
    have been converted to construction. The bridge curve often gets its
    tangency reversed. Sometimes the bridge curve will attach itself to the
    wrong end of an intersection curve. It seems like the tangent face
    constraint could eliminate all of these possible failure points.

    I really enjoyed your presentation. It could easily have run considerably
    longer.

    Jerry Steiger
     
    Jerry Steiger, Jan 28, 2008
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.