I need some help with a tablet I just installed. It's an old SummaSketch II. Got the windows drivers installed and did a test in windows and all is well. The tablet is set in WYPIWYG pointing mode. In acad I set in for WinTab Compatable and to accept table or mouse input. Using ACAD 2000 & windows 2000. The tablet driver is TWSER2KXP9.50.exe In ACAD you can use the mouse or the tablet, I used the tablet command to CFG the Tablet areas 1-4 and the screen areas. All seemed ok but the tablet menu is not working. The movement of the cursor with the puck is not restricted to the defined screen area of the tablet. Toggling the FLOAT button has no effect. I defined the fixed & float as the same area on the tablet. My tablet menu was in a 2nd menu I loaded with menuload. But I have tried to put the tablet menu code in the acad.mns file & that does not work either. (deleted acad mnc & mnr) I did try (MENUCMD "T1=OPTICADD.TABLET1") (MENUCMD "T2=OPTICADD.TABLET2") (MENUCMD "T3=OPTICADD.TABLET3") (MENUCMD "T4=OPTICADD.TABLET4") with no luck. Is there something else you have to do to activate the tablet menu system?