Tables

How does one create a data table in SW 2004? Can you use Excel to do
this? If so, how is this accomplished? I was able to create and insert
an Excel Worksheet into my drawing, my only problem now is that I see
the whole sheet, even the cells that don't have any data? I was hoping
to just insert the filled in cells. In the Excel document I set my
print area to no avail.

Any suggestions? Or is there a better method?

 

I have asked SolidWorks for a data table that acts like the new BOM,
Hole, or Revision tables, but haven't seen anything yet. Actually, a
revision table would work, but only one revsion table is allowed per
drawing. Tables can be created with an Excel file but it becomes an
embedded file in the drawing and, in my experience, it will not show
up on the drawing if the drawing is converted to a DWG file format. I
had the same problem with the SW2003 Excel BOM tables. It would be
great if SolidWorks could include a "data" table that would allow the
user to specify number of columns & rows, insert properties, etc.
Still waiting..... I haven't installed SW2005 yet, but from what I
have seen I don't think they added data tables to this release.

 

I had posted about the same problem earlier. 2005 does not have it
either. A "generic" table utility would be very useful!