SW2008-Views mixed up in 3rd angle projection

Discussion in 'SolidWorks' started by TOP, Jan 9, 2008.

  1. TOP

    TOP Guest

    It appears that SW is working in 1st angle even though it is set to
    3rd angle.

    I created a drawing using the back view as the first view. I then
    projected a top, bottom and right view. The problem is that the views
    are backwards as they would be in a 1st angle projection. SW is set to
    3rd angle projection.

    The assembly is set to 3rd angle, but started life in the iso standard
    and then was changed to the iso standard.

    Has anybody else seen this?

    TOP
     
    TOP, Jan 9, 2008
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 3rd Party dialogue box can't be surpressed?

  2. integrate 3rd party analog simulator into ADE?

  3. Using "Align Angle" or "Mate Angle" in assembling

  4. 3rd to 1st Angle

  5. SW2008 SP2.1 Initial Views

  6. SW2008-Revolved section projection misalignment

  7. SW2008 - Auxilary views out of alignment

  8. Drawing views are on an angle, how to change?

Loading...