SW2007 CTD

hey,

I'm on to my fourth CTD using Photoworks in SW2007. Trying to drag a
material onto a part and BAM, gone. Takes forever to re-start now too,
wheras in SW2006 was quite quick to get going again.

Photoworks in SW2006 has stopped working - it asks me to register each time
and then says it fails to initialize add-in component.

Any help?

 

Wow, no we haven't seen issues like this on 2007 SP 1. I hate to sound
like a tech support guy but maybe you need to re-install or run a
repair on your install. If you installed SW2006 and SW2007 to
different folders (ex c:/program files/ SW 2006) then you should be
able to run either version without issue as long as you're not mixing
2006 and 2007 files.


2007 SP1 actually boots really quickly. SP 0.0 was very slow to boot
but since installing SP1 its almost "instant open"

 

I'm with Rob. I've crashed once in the past several weeks, and that was
messing around with some obscure little detail with rollbacks and undos
and reloads.

Beta Photoworks crashed a lot for me, but that was months ago. Problems
like yours are usually maintenance or installation issues.