SW and the Romer Arm 300i?

Discussion in 'SolidWorks' started by Judora, Sep 20, 2004.

  1. Judora

    Judora Guest

    What is needed to Use Solidworks with a Romer Arm 3000i? Do i need add
    on software? I would like to be able to make comparison between our
    Solidwork model and the actual part. any info would be appreciated.
     
    Judora, Sep 20, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to estimate the size of the chip from the netlist?

  2. What does this message "The geometry which serves as the origin of the detailed view "A", on sheet X

  3. Can't animate arm with multiple joints

  4. Making the 2nd plate match the hole locations of the 1st plate

  5. Job - Faro Arm Technicians, 4 needed

  6. Digitizing arm that makes 100% accurate DXF's

Loading...