SW and C#

Discussion in 'SolidWorks' started by Freedom Elz, Feb 17, 2006.

  1. Freedom Elz

    Freedom Elz Guest

    Is anyone in here creating custom programns for Sw in here using C#?

    Is it even possible?
     
    Freedom Elz, Feb 17, 2006
    #1
  2. Freedom Elz

    CS Guest

    It is verry possible. if you go to the api downloads section of the
    support site there is a template download for a C#.net 2005 addin and
    there are SDKs for the older versions of .NET. I haven't used it
    though VB.net is my language of choice
     
    CS, Feb 17, 2006
    #2
  3. Freedom Elz

    TOP Guest

    The one API presentation I attended at SWW was solely C#.
     
    TOP, Feb 18, 2006
    #3
  4. Freedom Elz

    Bob Hanson Guest

    We have written projects in VB.Net and C# for Visual Studio 2003 and
    2005.

    Best regards,

    Bob Hanson
    Senior SolidWorks API Solutions Provider
    Centare Group Ltd.
    www.centare.com
     
    Bob Hanson, Feb 20, 2006
    #4
  5. Freedom Elz

    lcifers Guest

    Sure, it's possible. However, you might want to consider that VB is
    more widely used for SW automation. That means there are a lot more
    resources (in this NG and on the web) to support you in writing a VB or
    VB.NET app than there are for C#.

    Good luck.

    - Luther
     
    lcifers, Feb 21, 2006
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. pros and cons of setenv and vla-put-???

  2. treedepth and treemax and ram

  3. Program activate in a drawing and execute and an other one

  4. Cell libraries and place and route

  5. schematic check and save and the time stamps

  6. CFP: DTVCS 2008 - Design, Testing and Formal Verification Techniquesfor Integrated Circuits and Syst

  7. Global and local variables and environments

  8. Cdf and pcell. Init value and default value

Loading...