Surfaces and drawings

Discussion in 'SolidWorks' started by pmwh, Nov 1, 2004.

  1. pmwh

    pmwh Guest

    I am not up to speed on surfaces and how to use them. I usually don't
    need them. However, a part that I converted from Pro/E to SoildWorks
    has imported as one complete surface. This works great for creating
    assemblies (although you can't do interference detection or section
    views). Now when I insert a view into a drawing, none of the surfaces
    show up. Are there any tips/tricks to allow surfaces to show up in
    drawings?
     
    pmwh, Nov 1, 2004
    #1
  2. pmwh

    matt Guest

    Insert, Model Items, Surfaces



    wrote in @c13g2000cwb.googlegroups.com:
     
    matt, Nov 1, 2004
    #2
  3. pmwh

    pmwh Guest

    Matt: Thanks for the simple but effective answer

    Mike: I have run this "import diagnosis" and foun that it works on
    simpler parts. However, the part I am working with now has been
    imported from Pro/E and is a complex casting with a lot of small angles
    and radii. This SolidWorks tool does not work well in this application.
     
    pmwh, Nov 1, 2004
    #3
  4. pmwh

    matt Guest

    That's assuming that SW is set to make it a solid. In the Open dialog,
    when initially opening the translated file, go to the Options button, and
    make sure "Try forming solid" is turned on.

    matt
     
    matt, Nov 1, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.