Start point in pipe

Hello,

I am using pro/e wildfire 2.0 .
After creating datum points I used insert > advanced > pipe to create a
pipe passing through the daum points. But when I try to edit it (pipe)
and couldnt find the way to change the start point of the pipe.
All I want to do is delete the start point and change it to some other
point. Any help will be highly appreciated.

Thanks,
Nilesh

 

I'm using WF 3.0. If I define the pipe using the "whole array" option,
then whenever I add or remove a point from the point array the pipe
updates automatically.

 

But it doesnt give you control to change start point

 

Pick "Insert point", the prompt asks you for point to insert BEFORE, that's
your start point. When you've picked the start point, then pick the point
you want to be the new start point. I'm not 100% sure, but you may have to
remove any tangency constraints you set up on the Tangency page first..
However, I have used this to establish a new start point for a curve thru
points. It can be pernickety, but these are the basic steps.

David Janes