SolidWorks is unable to obtain required memory

Hi,

Just wondering how many people are getting this same message in SW
2008 when opening assemblies? We're getting it with moderate sized
assemblies that shouldn't be a problem.

Everybody in my office can repeat the problem and other colleagues I
know outside our office have encountered it too yet both local VARs
seem stumped by it.

Thanks
Devlin

 

Devlin,

Suspect there might be a geometry glitch in SW code that's gobling up
memory (software memory leak?).

SP 5.0 has been released but I don't think it will solve the issue.

I'm getting the same problem with SW2009 when rendering a simple part
image (square block). Again, geometry is such that it shouldn't be an
issue.

Had the identical problem when rendering a piping route. Removed the
3D sketch CL of the route and the rendering worked fine.

While not answering your question it may give SW/Vars something more
to go on.


Len

 

Saw this before on a regular basis on a 32bit system and 2Gb
ram.....but now after changing to 64bit and 8Gig of ram never seen it.

// Krister

 

"As annoying as a banquer." That's the funniest thing I've heard
today. You might have just coined a new term. Thanks