SolidWorks and Windows 7 anybody?

Discussion in 'SolidWorks' started by Jeppe Sorensen, Sep 16, 2009.

  1. Jeppe Sorensen

    Jeppe Sorensen Guest

    Anybody been testing W7 and SW?

    Good or bad?

    Best regards
    Jeppe
     
    Jeppe Sorensen, Sep 16, 2009
    #1
  2. Jeppe Sorensen

    tnik Guest


    A couple people have, I would check over at the solidworks forums, I
    know there's a big discussion over there about it.

    I'm currently using vista 64bit and sw, other than the few bugs that pop
    up, I wouldn't even think about going back to XP. Once Win7 drops a
    service pack, I'll switch over to it. Till then, I'm a happy camper.
     
    tnik, Sep 16, 2009
    #2
  3. Jeppe Sorensen

    Krister_L Guest

    Seen a few issues in other forums, and at SW website they say it's not
    supported it yet for a while. Need some heavy beta testing first the
    say.

    // Krister
     
    Krister_L, Sep 16, 2009
    #3
  4. Jeppe Sorensen

    manager Guest

    Matt Lombard has been. See the Dezignstuff blog.

    TOP
     
    manager, Sep 25, 2009
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Anybody doing EDM electrode design for molds in Solidworks ?

  2. Has anybody done a chain in Solidworks?

  3. Anybody ever used these notebooks for SolidWorks?

  4. Anybody run SolidWorks on a laptop with nvidia geforce go 7400 graphics?

  5. Anybody feel like answering a solidworks question?

  6. anybody using cam software imbedded in solidworks?

  7. Does anybody have experience with "CircuitWorks" for SolidWorks

  8. Anybody sucessful in using HP 350 C and HP 200 DesignJet Plotters for C and D sized plots?

Loading...