Simulation error message - SW2004

Discussion in 'SolidWorks' started by miket, Dec 29, 2004.

  1. miket

    miket Guest

    Hello,

    I have an assembly in which upon rebuild, I get the error
    message:

    "Simulation: This feature had an error in the last update. Edit
    definition on the feature to correct the problem".

    I cannot find what is being referred to here. Yes, I did run a
    simulation at one point, but now I cannot seem to clear it. How can I
    find where this is, and delete it?

    Thank you.

    Mike Tripoli
     
    miket, Dec 29, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. "Extra Right paren on input" Error Message

  2. error message: dbobji notifyReactors ?

  3. error message

  4. error message in routine.....help???

  5. Help with warning message from spectre simulation

  6. Question about a warning message in PSS+PNOISE simulation for LC VCO

  7. advance simulation time without running simulation and then re running

  8. Why this SW2004 error?

Loading...