Should I discard my old Spaceball 2003

Discussion in 'SolidWorks' started by New to SW, Sep 30, 2006.

  1. New to SW

    New to SW Guest

    Just starting up with 3D again this time with SW, Any one who knows if I
    could still use my SpaceBall 2003 from Spacetec.

    I installed the software to a SpacePilot with USB and expected that de
    drivers support different versions, am I wrong?



    Regards
     
    New to SW, Sep 30, 2006
    #1
  2. New to SW

    Reaper2561 Guest


    Hey,

    I believe you are correct on both points. You can use SpaceBall 2003
    and the drivers for these two products are different. Also, 2003
    drivers are hard to come by, but they can be found. I have it. I hope
    you do too.

    Reaper.
     
    Reaper2561, Sep 30, 2006
    #2
  3. New to SW

    New to SW Guest

    Thanks i found the driver here:
    http://www.treiber-online.de/3dconnexioninc-17/4.html
    Expect that it will work.
     
    New to SW, Sep 30, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. spaceball

  2. 10th FEM Workshop 2003 at the University of Ulm, 17th/18th July 2003

  3. Motor control - Spaceball

  4. Spaceball 3003, 3003C, 3003C FLX?

  5. Old Spaceball support to end March 1

  6. need drivers for Spaceball 2003???

Loading...