Sheet Metal Joggles

This is a typical part I model:

http://www.spiretech.com/~guynoir/sldwrks/sample part.zip

I would like to be able to insert the joggles as sheet metal embosses or
pallet features. Any ideas how this might be done?

Thanks,

--
J Kimmel

www.metalinnovations.com

"Cuius testiculos habes, habeas cardia et cerebellum." - When you have
their full attention in your grip, their hearts and minds will follow.

 

"the page cannot be found"

 

Because of the gap between sample and part in the address you need to
copy/paste the address into the browser or downloader, the address
ends with .zip, a downloadable zip file.

http://www.spiretech.com/~guynoir/sldwrks/sample part.zip

 

ah.

 

A sweep with guide curves should do the trick. What you need to do is
create all the guide curves and then create the profile and tie it to all
the guide curves then each point that is tied to guide curves will follow
that curve for the entire length of the sweep.

Corey