Same config as component<1>?

Discussion in 'AutoCAD' started by CS, Feb 2, 2005.

  1. CS

    CS Guest

    Ok maybe I am overlooking the obvious, but does any one have an Idea
    (excluding design table) for keeping Component<1> and Component<2> of the
    same Component on the same configuration. For instance I have a door with 2
    hinges. The Hinge component has a few configs say Opened Config and Closed
    Config. If hinge<1> is changed to Closed Config I need hinge<2> to also
    change to Closed Config. I suppose that patterning would work but I try to
    avoid paterning, and if you have 2 doors that you want to both follow the
    same thing it wouldn't work.

    Corey
     
    CS, Feb 2, 2005
    #1
  2. CS

    CS Guest

    Please disregard I did the wrong group again.
     
    CS, Feb 2, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Config Page Layouts Help

  2. Invalid Plot Config - AutoCAD Crash

  3. calculating a config word during operating point analysis

  4. How can rotate and translate a component at the same time ?

  5. Change 'config in use' into 'use named config' using API

  6. Same config as component<1>?

  7. Same Settings, Same Printer, Different Results

Loading...