Rx start without options

This may be us, but I would like some confirmations, please.

Start up SW2007 Rx (has to be 2007 - 2006 is fine) and click on "Click here
to launch SolidWorks while bypassing the Tools/Options settings" to do that.
Then try to open a new file.

On ours it keeps bringing up the box to set the units. It appears to be
stuck in a loop that won't ever let you open a new file in that mode. It
doesn't seem to be a SP issue as it behaves the same on 0 or 3.0.

Does anyone else see it? Does anyone else see it that installs straight
from the CDs? We do our installations across the network, but trying to
figure this out, the next step is to start with a clean machine and install
straight from the media, therefore the request. I have checked it on a
clean machine with only sp0 on it, and the action is the same, but that
install was also from the network.

WT

 

Wayne, same thing here, except we do individual installs at each
machine. It asked for the units, disappeared and did't let me start a
new part.
It also didn't have my file locations in tools options; I found this
out because macros wouldn't run after opening an existing file.

Diego

 

Same here....swx 2007, sp 2.2

Scott

 

Are these installs each instance with the CDs?

WT

 

Good - thanks - I'll get this new info turned in.

WT