Rotating A Plot

Discussion in 'AutoCAD' started by slowhnd, Jun 3, 2004.

  1. slowhnd

    slowhnd Guest

    I have a similar problem as was asked earlier about my plotter cutting off about 3" at the end of a "D" sized plot. I have a HP DesignJet 750C Plus plotter that is roll fed and am using AutoCad Lite. Currently I have to specify an "E" size sheet and run a "D" plot. What would be really nice is if I could rotate the plot at 90 deg and save paper. Can anyone help??
     
    slowhnd, Jun 3, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. rotating a point along an axis...

  2. Rotating 2 viewports at the same time (in Mspace)

  3. Inserting a block, and then rotating it!

  4. Rotating text on horizontal resistor as seen in Cadence Paper

  5. Wildfire Spinning Panning Rotating

  6. pro - wildfire, part disappear when rotating.

  7. Need to crate a rotating Solidworks model for a web page...

  8. SW2003: rotating parts in exploded view?

Loading...