relations markers 2005

Discussion in 'SolidWorks' started by MM, Sep 23, 2004.

  1. MM

    MM Guest

    OK, I know this has been discussed before but I can't find it.

    How do you turn of the annoying little relation markers in sketches,
    WITHOUT, turning off all inferencing. SW2005


    Regards

    Mark
     
    MM, Sep 23, 2004
    #1
  2. MM

    Zander Guest

    Hi Dale,

    I like them (and was used to them in MDT days) but I find at certain zoom
    levels sw is displaying a sketch relation (usually a coincident at and
    endpoint) over top of the endpoint whereby you can not select that point
    until they are turned off.

    Have you seen that?

    Zander
     
    Zander, Sep 23, 2004
    #2
  3. MM

    MM Guest

    Dale,

    I'll use em too. It's just a bit much to look at them all the time.


    Mark
     
    MM, Sep 23, 2004
    #3
  4. MM

    Richard Charney Guest

    I like them too (I was also used to them form my MDT days and Solidedge
    days). It's so much easier to see what's going on with a sketch, rather than
    having to select a line, arc, point, etc. to find out about any relestions
    it has.

    Richard
     
    Richard Charney, Sep 23, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. creating custom schematic check and save markers

  2. Removing Waveform markers in SKILL (awv)

  3. Who can I search in virtuoso layout editor DRC error markers witha certain error type

  4. Keyboard shortcut key to delete all markers

  5. SW 2005 Relations display

  6. how do I turn of the stupid relations icons on 2005 sketches?

  7. Diameter and Centerline Markers

Loading...