re-establish origin?

Discussion in 'AutoCAD' started by longshot, May 12, 2006.

  1. longshot

    longshot Guest

    if I have a file I would like to move the origin to 0,0,0 . so when I load
    as an xref it loads in the correct spot?

    thanks
     
    longshot, May 12, 2006
    #1
  2. longshot

    Michael Bulatovich Guest

    Does INSBASE also affect xref insertions? I dunno...
     
    Michael Bulatovich, May 12, 2006
    #2
  3. longshot

    Michael Bulatovich Guest

    Just looked it up, it does. Reset it as required.
    --


    MichaelB
    www.michaelbulatovich.ca

     
    Michael Bulatovich, May 12, 2006
    #3
  4. longshot

    Philippe Guest

    roy a écrit :
    Open the file then enter : BASE 0,0,0

    Philippe
     
    Philippe, May 15, 2006
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. lisp for copy/pasting at origin

  2. Different results whether WCS origin is visible or not

  3. Set X and Y origin value on a pagesetup

  4. Move all to origin help

  5. deleting origin marker on symbolic cell

  6. How to Redefine V8 Cell Origin

Loading...