radial dimension through center mark

Discussion in 'SolidWorks' started by samurai, Mar 31, 2007.

  1. samurai

    samurai Guest

    How do I get a radial dimension to go through the center mark of an
    arc with the arrow pointing to the arc?

    Everytime I try it, it dimensions to the diameter, not going through
    the center mark. I want it to dimension through the center mark, to
    the arc.
    It does dimension to the arc if I am on one side of the arc, but when
    I rotate the dimension 180deg, the arrow points to the diameter from
    outside the diameter circle. I press the arrow, and the arrow changes
    from outside the diameter, to the arrow pointing from the center mark
    to the outside diameter, but is pointing the wrong way. I want to to
    point to the arc.

    SW2006

    samurai.
     
    samurai, Mar 31, 2007
    #1
  2. samurai

    Dale Dunn Guest

    Have you tried this: Open the dimension's properties and toggle "dimension
    to inside of arc"?
     
    Dale Dunn, Apr 2, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Needed: Center Mark Lisp

  2. Not Getting "Select Via Layers for Mark Net" form while doing Mark Net

  3. Dim. Extension Gap form Center Mark

  4. Changing centerline and center mark fonts.

  5. Center mark size

  6. Is it me or center mark not ok?

  7. Linear Center Mark with Connection Lines

  8. Dimensioning to center mark rather than hole

Loading...