Queston on ADT2006

Hello,

I´m using ADT and have the following problem:
I have a wall that has two kind of wall styles on top of each other (lower
concrete and upper lighter structure). When I insert a window or a door into
the wall it "sinks" only into the other wall style, the other is not edited.
The result is that the window or the door doesn´t show in the other wall
style (in 3D).
Is there a way to do this so that adding a door will affect on both wall
styles?

Pekka
ps. English is not my native language in case the question is difficult to
understand...

 

My response is based upon the assumption that you question is about 2
different wall styles side by side, not one above the other.
The long answer is to have you create a single wall style that incorporates
all the features of the 2 different styles.
Now the short answer - insert an opening in the "other" wall the same size
as the window or door. This work around will not work if you are need to
place the door and/or window in the center of or between the walls.