Protocol for Tabulated/Charted Drawings

Discussion in 'SolidWorks' started by Tim@Kann, Aug 25, 2003.

  1. Tim@Kann

    Tim@Kann Guest

    Looking for information on what criteria used when creating tabulated
    drawings. Example: Is Form, Fit or Function always maintained. Can width
    and length be both tabulated on the same drawings? Does anyone have any
    documented specifications as to which they follow? Any help would be
    appreciated.

    Thanks
     
    Tim@Kann, Aug 25, 2003
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Design Table / Charted Drawing, Help Please!

  2. Charted Detail Drawings in SW.

  3. Charted drawings - Models warped but flat drawing charted

  4. Multiple Sheet Drawings vs. Single Sheet Drawings

  5. Whereis for Charted Parts

  6. Could you use "mark for drawings" for only a few dimensions at once.

  7. Output of SW drawings to Colour Acad drawings or colour output of SW plots

Loading...