projecting edges into a sketch

Discussion in 'SolidWorks' started by wwswimming, May 10, 2005.

  1. wwswimming

    wwswimming Guest

    insert - edge - use ... in pro-e

    "project" ... in one-space designer

    but i can't figure out how to do it in solidworks. when i'm in sketch
    mode, how do i sketch/ project an edge, if it doesn't highlight a
    vertex/edge to create an arc or line with ?

    thanks !
     
    wwswimming, May 10, 2005
    #1
  2. wwswimming

    matt Guest

    "convert entities"?



    wrote in @o13g2000cwo.googlegroups.com:
     
    matt, May 10, 2005
    #2
  3. wwswimming

    wwswimming Guest

    thanks a lot !

    got that detail designed in.

    for some reason it's not edge projecting/ entity converting when i pick
    an edge on a surface of an object that is co-planar with the sketch i'm
    working on.

    but when i mouse over the complementary surfaces offset from the
    "current sketch", then the edges convert into lines all right.
     
    wwswimming, May 10, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.