ProE Translator in SW 2004 sp1

Discussion in 'SolidWorks' started by calidude, Nov 2, 2003.

  1. calidude

    calidude Guest

    Has anyone noticed that the ProE translator has been put back in to
    service pack 1? I think it works on all versions except Wildfire.

    Cali Dude
     
    calidude, Nov 2, 2003
    #1
  2. calidude

    pipsqueek Guest

    Where is SP1??
     
    pipsqueek, Nov 2, 2003
    #2
  3. calidude

    Scott Guest

    on early visibility... If your not on it then it's not available to you yet.

    Regards,
    Scott
     
    Scott, Nov 2, 2003
    #3
  4. calidude

    kellnerp Guest

    SP1 isn't out yet and those that have it aren't supposed to talk about it.
     
    kellnerp, Nov 3, 2003
    #4
  5. calidude

    Dave H Guest

    John,

    I'm just running SP0 but printing to our 750c is not a problem. It's a
    network printer not connected directly to any of the SolidWorks boxes.

    Dave H
     
    Dave H, Nov 3, 2003
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.