Problems with soc encounter output to Magic

Discussion in 'Cadence' started by renee, Aug 15, 2008.

  1. renee

    renee Guest

    I had problems when I exported the routing results from soc encounter
    to Magic.

    In the SoC encounter, after verifying the results, I saved the design
    in GDS format, and read it into Magic. But it said that there were
    instances as control_VIA0 and control_VIA1, which I think were the
    generated vias instances. But I don't have these vias defined in
    Magic, so when I read the stream file in Magic, it said that it cannot
    find the cell control_VIA0 and control_VIA1.

    Meanwhile, in the soc encounter, the wires indeed connected to the
    edge of the cell, but when it was imported into Magic, some wires
    extended over the edge of the cell, while some did not. I don't know
    why it happened.

    Thanks in advance!



    Renee
     
    renee, Aug 15, 2008
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. what must be associated in verilog file with LEF when imported in the SOC ENCOUNTER?

  2. SoC Encounter

  3. SoC Encounter via array.

  4. About floorplan and route using SOC Encounter

  5. problem about timing analysis in soc encounter

  6. What do these two tools used in?? (1st Encounter / Soc Encounter)

  7. Problem with SoC Encounter 7.1

Loading...