plotting lambda and Kappa in cadence

Discussion in 'Cadence' started by Uncle Ezra, Oct 28, 2004.

  1. Uncle Ezra

    Uncle Ezra Guest

    how do you get lambda and Kappa (u_nC_ox) of a transistor and plot it
    against some sweep variable? Any suggestion will be helpful.

    Thanks
     
    Uncle Ezra, Oct 28, 2004
    #1
  2. Uncle Ezra

    fogh Guest

    1-write your netlist, using the command :
    ed input.scs
    2- run the simulation and type in the cadence prompt:
    getData( "Kappa")

    But you can not get the lambda using SKILL. You will need SKILL++
     
    fogh, Oct 28, 2004
    #2
  3. Uncle Ezra

    Andrew Beckett Guest

    Is that supposed to be a joke?

    Andrew.
     
    Andrew Beckett, Nov 1, 2004
    #3
  4. Uncle Ezra

    fogh Guest

    Yes of course, Andrew. Do you find that an RTFM answer would be better
    humor ?
    I guess cds takes already good enough care of academics that I can
    afford these jokes , no ?
     
    fogh, Nov 2, 2004
    #4
  5. Uncle Ezra

    Andrew Beckett Guest

    It was just a bit oblique for me (since you can use lambdas in SKILL,
    it wasn't correct either), and I didn't think that most readers would
    recognise it as humour... especially not the original poster.

    I've no problem with jokes - just try to make it a little more obvious
    when you are joking!

    Cheers,

    Andrew.
     
    Andrew Beckett, Nov 2, 2004
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. don't use lambda

  2. a better way - apply/mapcar/lambda/mapcar/lambda

  3. mapcar / lambda help please

  4. returning lambda from a conversion function

  5. Lambda makes my head spin

  6. I want lambda more clear

  7. hspice level 3-->kappa=0 == spectre?

  8. Different Results between Unix Cadence 4.46 and Linux Cadence 5.032

Loading...