please look into this problem

I am drawing a rectangle and saving as abc.sec, then i am opening a
new file in sketcher mode then when i am importing the sketch>data
from file option 'abc.sec' the snap point is middle of the
rectangle.
But i want the snpping point to be a corner of the rectangle. How to
do it? can any body help me?

 

In WF3 when you select 'sketch>data from file' you can click the point
on the
screen to import the sketch. After importing, with the RMB you can
'drag' the
center of the sketch to a new position and with the LMB you can 'drag'
the
sketch position.
In WF2 when you select 'sketch>data from file', the sketch is imported
directly into your new sketch file in scale 1:1.

 

hi friend you can solve this problem by drawng two references on both
the ends and drawing refe. on both of the edges u can will get it
centralised and it will sit in the centre of the both the planes ok.

regards,
harish.p