PDF Plots and Non-Rectangular Viewports

Discussion in 'AutoCAD' started by Mark Castle, Aug 17, 2004.

  1. Mark Castle

    Mark Castle Guest

    When we try to plot PDF files in AutoCAD 2005 with the Adobe PDF Converter
    and the drawing contains non-rectangular viewports we only get about 2/3 of
    the sheet with the remainder cut off. If we delete the clipped viewport the
    PDF comes out fine. I briefly searched the newsgroup for posts on this issue
    and did not find any. Is anyone else experiencing this and is it a known
    issue. Thanks for any information provided.

    -Mark
     
    Mark Castle, Aug 17, 2004
    #1
  2. Mark,

    If you want to etransmit them over to me I'll test them through our software
    to see how it does. Also what page size and resolution were you trying to
    send it to. It appears that AutoCAD likes to chop off if the
    width*length*resolution*complexity of drawing is too high going to PDF
    drivers.

    --
    Rodney McManamy
    President
    CADzation
    -------------------------

    -------------------------
    518 South Route 31 Suite 200
    McHenry, IL 60050
    www.cadzation.com
    Providing Industrial Strength
    PDF & DWF Solutions to the
    Global CAD Marketplace.
     
    Rodney McManamy - CADzation, Aug 17, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.