PC3 file

Hi,

I have a macro that makes a dwf of every drawing. In that macro I use a pc3
file. Everything goes right, except for the paper boundaries. I want the
drawing to end up within the paper boundaries set in the pc3 file, but it
ends up next to it of above it. I also used the "show paper boundaries"
checkbox, but that doesn't work either (when it's off it shows
paperboundaries and when it's on it shows paperboundaries?!).

Can anybody tell me how to make this work?

Thanks,
Frank

 

I'm not sure what you mean by "it ends up next to it of above it.", but
"show paper boudaries" only applies to paperspace. Note where you are making
that setting, its a layout element, not part of the plot. A plot *always*
has to have boundaries. Printers can't print all the way to the edge due to
the feed mechanisms.