Pattern a part question

I would like to pattern a part off of a sketch in an assembly (I can do
this this is not the issue) and then I want have all the individual
entities (parts) get a unique name and be saved as a unique part.

I would assume I would just dissolve the pattern but then how to I get
each part to pick up a unique name and then save out as a new part?

How would I go about doing this?

Ben

 

You can't do that from an assembly, but if you pattern them as bodies
inside a part and then use the Save Bodies command, you can save each of
them to a different file name. I'm not sure what you're trying to do
after that, but you will have a "base part" situation, rather than
having independent feature trees.

Depending on what you're trying to do, this might also be a good use for
configurations.

Matt

 

Seth

I was thinking of doing that but there are a lot of parts to deal with
here, guess I will have to quit being lazy and just do it

Thanks

Ben