Part Naming Convention

Discussion in 'SolidWorks' started by Len K. Mar, Aug 1, 2003.

  1. Len K. Mar

    Len K. Mar Guest

    Hi,

    In my travels I've come across zillions (okay I'm fibbing just a wee
    bit) of company standards for namiing SW parts and Assemblies. I've
    yet to come across two that are identical.

    I am assuming that there is a detailed standard out there (MILSpec
    perhaps)that specifies the naming rule convention and categories.

    Note - I'm looking for detailed information as opposed to general
    guidelines as indicated in the Drawing Requirements Manual.

    Any suggestions would be appreciated.

    Thanks in advance,

    Len
     
    Len K. Mar, Aug 1, 2003
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. (FYI) Tool & Mold EXPO, Anaheim Convention Center, Anaheim, Ca

  2. naming convention help

  3. Data Management (Naming Convention) Poll

  4. naming convention of part files for assembly files

  5. Part naming, adding intelligence?

  6. B.S. convention for springs

  7. pdf plotting and naming convention

Loading...