Part, Gate & Runner Analysis

Discussion in 'SolidWorks' started by Bo, Sep 5, 2006.

  1. Bo

    Bo Guest

    Are Mold Flow's offerings the best bang for the buck in working with
    SolidWorks to give mold fill, gate and runner analysis issues clear
    results for improving the molded part and molding cycle times?

    I just haven't used these tools before except for Mold Flow Express.

    I compared the fill of a well known part in Express vs the full Mold
    Flow and found that though the cavity fill was nearly the same and
    proportional (% times to fill to certain points), the limited options
    inside of Express gave fill times that were twice what the actual full
    version of Mold Flow gave.

    I don't have any experience with any other similar applications.

    Bo
     
    Bo, Sep 5, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to get dc operating point data from a swept dc analysis or aparametric dc analysis in ocean

  2. Random logic verilog gate netlist generator

  3. Can I do LVS between gate netlist and transistor netlist in Diva?Thanks

  4. how to perform gate-level simulation with verilog-XL

  5. gate-level simulation problem

  6. gate sizing and interconnect delay

  7. DC analysis gain differs from AC analysis gain

Loading...